Table of Contents
Advertisement
5.11. Bottom heat protection shield
Additionally protects the carriage from the influence of a high temperature. To install,
loosen five screws with the 3 mm hex wrench, slide the shield under the heads of the
screws according to the direction of the arrow, and then tighten the screws.
Screws for fixing the bottom shield
5.12. Magnetic unit
Allows clamping the track to ferromagnetic surfaces. The holding force on a 5 mm
(0.2'') thick surface is 900 N up to a temperature of 100°C (212°F). At 180°C (356°F)
the force decreases to 540 N.
Use the 4 mm hex wrench and two M6x12 screws to tighten the unit to the track,
and then set the levers to the position 'I'.
Part number:
ZSP-0475-56-00-00-0
Copying, using, or distributing without permission of PROMOTECH is prohibited.
Part number: OSL-0475-53-00-00-0
This document is protected by copyrights.
22
DRAGON (HS)
Advertisement
Table of Contents
