Shure MXA910 Manual page 28

Note: If using conduit to contain the cable, the optional junction box accessory (model A910-JB) mounts directly to the rear panel of the microphone.
Painting Components
The grille and frame of the array microphone can be painted to blend in with room design. Some basic disassembly is required
for painting.
Step 1: Removing the Frame and Grille
1. Remove the screws that hold the main assembly on the frame (6 screws per side). There are washers between these
screws and the rear panel.
Important: Do not remove the screws that are farthest in the corner and recessed into the panel (see graphic).
2. Carefully lift the assembly out of the frame.
3. Remove the gray plastic LED lightpipe. Leave the black plastic guide in place.
4. Remove all 4 screws from one side of the frame (see image).
5. Remove the side of the frame.
6. Slide the flat grille out of the frame for easy removal of the foam piece.
7. Carefully remove the foam piece from the grille. Pull from the edges, where it is attached with hook and loop fastener
strips.
Important: Do not paint the foam.
(1.1) Removing the screws to detach the main assembly
Shure Incorporated
28/59