Setup For Retrofit Panels; Defining Your Regulator-The <Configure> And <Adv Configure> Menus - Siemens MJ-5 Installation And Operation Manual

4 Setting Up the MJ-5 Control Panel

4.2 Setup for Retrofit Panels

If you are retrofitting either a G. E. or Cooper regulator for
use with the Siemens MJ-5 Control Panel, please refer to
the Appendix. Contact your Siemens representative for
details.
4.3 Defining Your Regulator—
The <CONFIGURE> and <ADV
CONFIGURE> Menus
When the MJ-5 Control Panel is delivered pre-installed on
a regulator, many of the configuration variables are already
set. However, the MJ-5 Control Panel provides a wide
range of additional variables that can be used to make the
regulator perform more effectively in your system.
Variables in the <CONFIGURE> menu are summarized in
Table 4.1; variables in the <ADV CONFIGURE> menu
are summarized in Table 4.2; both menus are explained in
the following pages.
Figure 4.1 Typical Siemens Regulator Nameplate for older ANSI Type B (Inverted) Regulator
Note: Items are not highlighted on actual nameplate
Siemens Industry, Inc.
Figures 4.1 to 4.4 show typical Siemens regulator name-
plates. Refer to these figures for information that can be
obtained from Siemens regulator nameplates
17