Setup; Setup Menu; Editing Parameters; Standard Commissioning - Siemens Sinamics BOP-2 Operating Instructions Manual

Setup

Setup menu

The setup menu is a fixed sequence of screens that allow the user to perform the standard
commissioning of the Inverter.
Once a parameter value has been modified, there is no possibility to cancel the standard
commissioning process. In this case, the standard commissioning process must be
completed. If no parameter value has been modified, then a short press of
previous screen and a long press (more than 3 seconds) of
Monitor menu.
When a parameter value has been modified and the new value confirmed by pressing
then the next parameter in the standard commissioning sequence is automatically displayed.

Editing parameters

Parameters can be modified use two methods; scrolling through the parameter values or
using the single digit methods. See Parameters (Page 33).
NOTICE
Important information on the latest changes to the firmware
There has been some major changes to the way that the commissioning software has been
implemented and it is recommended that you read all the information given at the following
links to the Siemens Industry Online Support (SIOS) site:
• SINAMICS G120 Firmware V4.7 SP3 - Modified commissioning behavior
(https://support.industry.siemens.com/cs/ww/en/view/109480663)

Standard commissioning

The Standard commissioning process requires the input of data which is specific to the
motor to which the Inverter is connected. The data regarding the attached motor can be
gathered from the motor's rating plate. An example of a typical motor rating plate is shown in
the following figure:
Basic Operator Panel 2 (BOP-2)
Operating Instructions, 02/2016, A5E37143404B AA
Modified commissioning behavior
10
returns to the
returns to the top of the
,
37