Setting Up The Quick Key - Siemens MJ-5 Installation And Operation Manual

4 Setting Up the MJ-5 Control Panel

MAC: This item will display MAC address of the
network.

InitDataPort: This item it used to reinitialize the
front data port in case of loss of communication.
If panel is not communicating to MJXplorer or
DNP Config tool, then the user can press
change/save key and select yes. This will
reinitialize the data port.

U: This item is for Diagnostic purposes to check
if calibration is done.

P: This item is for Diagnostic purposes to check
if calibration is done.

C: This item is for Diagnostic purposes to check
if calibration is done.
The <DIAGNOSTICS> menu also includes the Serial
Number and Product Revision code for the MJ-5 Control
Panel. These are set at the factory and cannot be changed.
The configurable tap changer control settings are also
contained in the <DIAGNOSTICS> menu. Contact your
Siemens representative for more information before
adjusting these settings.

4.10 Setting up the Quick Key

The Quick Key provides access to the customizable Quick
List. The Quick List can be used to step through a series of
up to 15 user-set menu items. The Quick List allows
creation of a custom menu with the minimal amount of
effort. Any changes to the menu parameters must be done
using normal configuration and operation procedures.
Certain menus cannot be added to the Quick List including:
Password menu, Log menu(s), Alert menu. Press the Quick
Key repeatedly to step through the Quick List.
Siemens Industry, Inc.
Adding Items to the Quick List:
Use the scroll keys to display the desired menu item to be
added. Press and hold the Quick key for 3 seconds. The
phrase "Quick Added" will appear indicating that the data
item has been added.
Removing Items from the Quick List:
Press the Quick Key repeatedly to display the menu item to
be removed. Once the desired item is selected, hold the
Min/Max key for 3 seconds. The phrase "Quick Delete"
will appear on the display.
36