Using The Td 200 Setup Menu Option; Setting The Network Address Of The Td 200 - Siemens SIMATIC TD 200 User Manual

Operating the TD 200
3.8

Using the TD 200 Setup Menu Option

The TD 200 Setup menu allows you to set the network address of the TD 200 and
the S7-200 CPU, the address of the parameter block (stored in V memory of the
CPU), the baud rate, and other communication parameters. The display contrast
adjustment is also available in the TD 200 Setup menu.
The network addresses allow the TD 200 to be connected to a network with
multiple master and slave devices. Entering the address where the TD 200 looks
for its parameter block allows you to have several TD 200 devices connected to a
single CPU.
Note
Pressing ESC while not editing a value returns you to the Display Message mode.
If any of the Setup menu items have been changed, the TD 200 stores the new
values permanently and reinitializes the communications to the CPU.

Setting the Network Address of the TD 200

The Setup Menu allows you to enter the network address for the TD 200. (The
default address for the TD 200 is 1.) Use the following procedure to change the
network address for the TD 200:
Key
1.
ESC
2.
3.
ENTER
4.
ENTER
3-16
Action
The TD 200 enters the Menu mode.
The TD 200 scrolls down the menu
options five times.
Press to move the cursor to the
ENTER
address field. Use the up or down
arrow keys to display the correct
address.
Press to store the new address
ENTER
for the TD 200.
Display
MENU MODE:
VIEW MESSAGES
SETUP MENU:
TD 200 ADDRESS
SETUP MENU:
TD 200 ADDRESS
SETUP MENU:
TD 200 ADDRESS
SIMATIC TD 200 Operator Interface
C79000-G7076-C272-01
1
1
2