Initial Setup - Siemens SINAMICS IOP Getting Started Manual

Fitting the IOP to Inverter
The IOP is fitted to the Control Unit of the Inverter by the following process:
Place the bottom edge of the IOP casing into the lower recess of the Control Unit housing.
Push the IOP forward until the top fastening clicks into place in the upper recess of the Control Unit housing.
Initial Set-up
Once the IOP is fitted and powered-up it will automatically detect the type
of Control Unit and Power Module to which it has been fitted. After the
initial start-up screen it will display the details of the Control Unit and Power
Module.
After the Identification screen has been displayed the main status screen is
displayed. If the menus are not shown, press the OK wheel to display the
menus.
The status icons used on the menu are explained below.
5
SINAMICS IOP, Getting Started Guide 01/09 - A5E02449215B2