Setting Up The Mj-5 Control Panel; Setup-Overview - Siemens MJ-5 Installation And Operation Manual

4 Setting Up the MJ-5 Control Panel

4 Setting Up the MJ-5 Control Panel
4.1 Setup—Overview
MJ-5 Control Panel setup procedures allow you to
customize the control panel to your needs and to the
environment in which it is installed. You can describe
specific regulator parameters and power-flow conditions,
and define automatic-mode operation. Previous generation
controllers used dip switch settings and jumpers for this
purpose. With the MJ-5 Control Panel, simply use front
panel touch-keys and the display screen to define the
operating environment. Also, the MJ-5 communication
facilities in conjunction with the MJXplorer software can
be used to set up the MJ-5 Control Panel.
The setup process for the MJ-5 Control Panel consists of
several steps:
Configuration
In this step, use the <CONFIGURE> menu to describe the
regulator and the power distribution system. Use the
<ADV CONFIGURE> menu to adjust optional or
advanced settings if desired.
Set Points
In this step, use the <REGULATOR> menu to define
Automatic Mode set points (voltage level, bandwidth, time
delay, etc.).
Logging Requirements
In this step, use the <LOG SETUP> menu to define data
logging requirements (what values you want logged, how
often, under what conditions, etc.).
Security Definition
In this step, use the <PASSWORD> menu to define
passwords and to activate security protection.
Table 4.1 The <CONFIGURE> menu
Siemens Industry, Inc.
Communications Definition
In this step, use the <COMMUNICATIONS> menu to
define communications parameters (baud rate, unit address,
etc.).
This chapter describes each of the setup parameters, and
explains how they are defined. The Communications
Module Instruction book contains additional detail and
background information to help you make the proper
selections.
15