Key Features And Functions; Multiple Inputs; Battery Charger Of Stationery/Service Battery; Vehicle Battery Charger - Projecta INTELLI-RV PM200 Instruction Manual

2. KEY FEATURES AND FUNCTIONS

2.1 Multiple Inputs

PM200 master power unit may have many
sources at one time. These sources include the AC
mains, solar panel and starter battery (Auxiliary).
Only one of them will be dominated to provide
power at one time, even if all are available,
priorities are listed to the right.

2.2 Battery Charger Of Stationery/Service Battery

The charger automatically starts when the appropriate qualified power is connected, either from grid, generator or solar.
With multiple charging stages (soft start-bulk absorption float-recycle), PM200 is designed to fully charge battery quickly. To guarantee
the optimal charging for batteries of different states, the PM200 features Microprocessor-controlled charging algorithm. The Float and
Recycle charging programs guarantees that the battery condition does not change despite being connected for a longer period.
11.5V
VOLTAGE
lcc
CURRENT
½ lcc
STAGE
SOFT START
1
1 SOFT START
Increases battery life by gently starting to charge the battery 5% of bulk
2 BULK
Reduces charging time by delivering maximum charge to set voltage life
by gently starting to charge the battery 25% of bulk
Battery temperature compensation charging
The BTS PM30 (Battery Temperature Sensor) supplied with PM200, measures the temperature of the battery and automatically adjusts, in real
time, to charge the battery properly at compensation rate of – 4mv±10%/°C/cell. In case BTS is not present, the PM200 will use 25°C as default.
Voltage compensation charging
With a voltage sensor PM30 the PM200 can, if required, automatically adjust its output to compensate the voltage drop caused by a cable.
This assures the right voltage is being delivered for optimal charging.
Adjustable charging capacity
Users can adjust the charging current by specifying the battery capacity. The charging current is set at threshold rate of 10% the of the
battery capacity (I = 0.1C) by default.
Lithium battery charging
The PM200 can be configured to charge Lithium battery. With the Lithium battery, the max charging current will automatically be set at
30% of battery capacity (Imax=0.3C).

2.3 Vehicle Battery Charger

Along with a powerful charger for service battery, PM200 offers a float charge of up to 3A to keep the starter battery charged, whether
connected to the AC main or PV. When starter battery is less than 12.4V, the PM200 starts charging after 30 minutes delay and stops
charging when voltage reaches 12.8V.
2.4 Power Supply Mode
If no battery is attached to PM200 unit, it will work as a power supply automatically with a 12.8VDC output.
Table 3 Source priority
AC MAINS
SOLAR
AUXILIARY
DOMINATING SOURCE
10 days
BULK ABSORPTION FLOAT
2 3 4
X
X
AC MAINS AC MAINS
1 hr
5mins
RECYCLE
5
3 ABSORPTION
Ensures a full charge to the battery without overcharging
FLOAT
4
Float charge maintains the battery at 100% charge
5 RECYCLE
X
X
X X
AUX
Figure 6
Charging Algorithm
Icc is the rated current.
7