Display; Water Tank Probe; L.e.d Display - Projecta INTELLI-RV PM200 Instruction Manual

1.2 L.E.D Display

N LABEL
O
1 Water pump
2 Night mode
3 Load
4 Fresh water tank
5 Tap water tank
6 Waste water tank
7 Starter battery
8 Service battery
N LABEL
O
1 Main
2 PV
3 Fault

1.3 Water Tank Probe

For PM200, max three probes can be controlled in the system.
NOTE: Always check the probe required for the water tank before purchase. If the probe included does not fit the water tank,
please contact the seller.
There are 2 probe styles:
PMWS200:
• Side installation
• Suitable for water tank
• Depth >200mm
6
Table 1 Front panel of PMSWLED
TYPE
DC load control
Scene mode
DC load control
Sensor
Sensor
Sensor
Voltage
Voltage
Table 2 LED indication of PM260
COLOUR STATUS
ON
Green
Flash
OFF
Solid
Green
Flash
OFF
ON
1 flash
2 flash
Red
3 flash
4 flash
5 flash
6 flash
Figure 4 PMWS200
Figure 3 PMSWLED switch panel
DESCRIPTION
Load control, on/off control
Refer to 2.10
Load control, on/off control. Refer to 2.7
Detect the level of fresh water tank
Detect the level of tap water tank
Detect the level of waste water tank
Detect the voltage of starter battery
Detect the voltage of service battery
DESCRIPTION
Battery charged or power supply mode
Battery charging under grid electricity
NO AC input
Battery charged
Battery charging under solar energy
NO solar input / AC charging / Aux charging
Short circuit
Service battery voltage low
Service battery voltage high
Over temp (heat sink)
Bulk charge timeout
VCR anomaly
Over temp (environment)
PMWS400:
• Side installation
• Suitable for water tank
• Depth 300-400mm
Figure 5 PMWS400