System Introduction Pm100-Btj; Features - Projecta INTELLI JAY PM100-BTJ Manual

1. System Introduction PM100-BTJ

PM100-BTJ is designed for use in caravans or motor homes. The PM100-BTJ is designed for an easy
installation and a user-friendly interface without the need for a highly tailored cable harness.

1.1 Features

• Smart battery charger 12V 30A
– Multi-chemistry charging supports lead acid (AGM, GEL,
WET) and lithium batteries
– High efficiency, max 88%
– With Power Factor Correction (PFC)
• 35A Power Supply
• Battery charging relay 12V 60A
– 60A continuously and 100A for 30mins
• Battery Low Voltage Protection
– Automatic disconnection when battery voltage is lower
than 10.5VDC (lead acid) or 11.2VDC (lithium)
– Delay time is 60s
• 10 x Fused DC outputs (2 x 15A, 8 x 10A)
• Thermal-controlled fan
• Water Level Monitoring
– Up to two tanks plus a waste tank
TRANSFORMER BLOCK DIAGRAM
AC Mains
Load
Switch
15A DC- 10A DC-
MULTIPLE CHARGING INPUTS
The PM100-BTJ has two inputs, AC mains and vehicle battery.
Only one source will provide power at a time, with priority
given to AC mains if available.
1.1.1 Output Power Isolation (Load Switch – If Connected)
The Load Switch will turn OFF output power on +L2 to +L10 (except +L1 – Always ON).
This switch will also cut power to the Bluetooth module if AC Mains is not connected, the system will be in Storage Mode.
4
+
AC / DC
–
BLVP
15A 15A 10A 10A
Load-
15A DC+ 10A DC+
PM100J Transformer Unit
VCR
Shunt
Shunt
Load+ House- Vehicle- House+ Vehicle+
AC MAINS
AUX (VEHICLE
BATTERY)
DOMINATING AC MAINS
SOURCE

