Removing the Processor Heatsink Module from the Motherboard
Before removing the processor heatsink module (PHM), power down as described in Section
3.1.
1. Using a T30 Torx-bit screwdriver, loosen and remove the screws on the PHM from the
socket, starting with the screw marked #4, in the sequence of 4, 3, 2, 1.
2. Pull up the PHM while releasing the small snap tabs on two corners of the socket.
Removing the screws in
the sequence of 4, 3, 2, 1
#4
#1
Printed Triangle on Motherboard
Figure 3-6. Removing the Processor Heatsink Module
Chapter 3: Maintenance and Component Installation
#2
#3
31
CPU Socket
After removing the screws,
lift the Processor Heatsink
Module off the CPU socket.