Chapter 2: Hardware Setup; Crosssync Hardware Requirements - LeCroy CrossSync User Manual

Hardware Setup

CrossSync Hardware Requirements

The CrossSync capability requires that analyzers are connected using their Sync ports.
CrossSync can be used with the built‐in Sync port included on every Advisor T3 and Sierra
M6‐1 analyzer. For owners of LeCroy's Sierra, Summit T3, and Voyager M3i based
analyzers, the CATC Sync port requires the optional expansion board (ACC‐EXP‐002‐X). Up
to eight analyzers may be connected in a single chain.
The AdvisorT3 and Sierra M6‐1 use the built‐in Micro‐D Sync port and only require the
Micro‐D Sync cable (AC031XXA‐X).
Systems with an expansion slot (such as Sierra M6‐4, Sierra M6‐2, SierraFC M8‐4, Voyager
M3i, and Summit T3‐16) require the CATC Sync Expansion Card and DB‐9 Sync cable (ACC‐
EXP‐002‐X).
The Kibra 380 DDR3 and PCIe Summit T28 use built‐in DB‐9 sync ports and require a DB‐9
sync cable (ACC‐EXP‐002‐X).
Analyzers daisy‐chained via sync cables will automatically synchronize time stamps,
trigger, recording start, and recording stop.
CrossSync User Manual
Chapter 2
3