Software
CrossSync Software Overview
The CrossSync control panel does not have a separate installer and instead is embedded in
the Protocol Suite installers.
The solution includes a lightweight software control panel that starts and stops recording
across daisy‐chained analyzers. Users can sync or un‐sync traces on‐the‐fly. The Time Tune
feature provides a real‐time slider for adjusting the off‐set between displays. This makes it
easy to see latency across busses.
Use the Time Tune slider to adjust the
off‐set between displays
Open previously captured traces which
remain synchronized
Un‐sync traces to scroll each window separately
Figure 3.1: CrossSync Control Panel
The CrossSync control panel requires the analyzers to be connected using their Sync ports.
This Sync port is built‐in to every Advisor T3 and Sierra M6‐1 analyzer. For owners of
LeCroy's Summit T3, Voyager M3i, and Sierra ‐based analyzers, the Sync port is available as
an optional expansion board (ACC‐EXP‐002‐X) that can be installed by users in just a few
minutes. This allows developers to leverage analyzers already in the lab to help resolve
multi‐protocol problems at the system level.
CrossSync User Manual
Start and Stop Synchronized Recordings
Easily Discover and Sync Analyzers attached to the system
Chapter 3
15