Connecting An Advisor T3, A Voyager M3I And A Summit T3-16 - LeCroy CrossSync User Manual

Host PC Connections Using Various Configurations

Connecting an Advisor T3, a Voyager M3i and a Summit T3-16

This configuration requires the optional Micro‐D to DB‐9 sync cable (AC030XXA‐X).
This example shows connecting an Advisor T3, a Voyager M3i USB and a PCIe Summit T3‐
16 analyzer. To do so perform the following steps:
1. Make sure to stop any recordings in progress.
Note:
You may plug/unplug the sync cable while the analyzer unit is powered on.
2. Connect the Micro‐D end of the sync cable to the Sync/Data port of the Advisor T3.
3. Connect the male end of the DB‐9 cable to the SYNC IN port of the Voyager M3i.
4. Connect the female end of the DB‐9 cable to the SYNC OUT port of the Summit T3‐
Figure 2.4: Daisy-chaining an Advisor T3, a Voyager M3i and a Summit T3-16
CrossSync User Manual
16.
LeCroy Corporation
9