LeCroy Corporation
Connecting an Advisor T3 and a Sierra M6-2
This configuration requires the optional Micro‐D to DB‐9 sync cable (AC030XXA‐X).
To do so perform the following steps:
1. Make sure to stop any recordings in progress.
Note:
You may plug/unplug the sync cable while the analyzer unit is powered on.
2. Connect the Micro‐D end of the sync cable to the Sync/Data port of the Advisor T3.
3. Connect the male end of the DB‐9 cable to the SYNC IN port of the Sierra M6‐2.
Figure 2.3: Connecting an Advisor T3 and a Sierra M6-2 Analyzers
8
(Alternatively, connect the female end of the DB‐9 cable to the SYNC OUT port of
the Sierra M6‐2.)
Host PC Connections Using Various Configurations
CrossSync User Manual