Connecting Three Analyzers With Db-9 Sync Ports - LeCroy CrossSync User Manual

LeCroy Corporation

Connecting Three Analyzers with DB-9 Sync Ports

The following example shows how to daisy‐chain 3 analyzers with DB‐9 sync ports. To do
so perform the following steps:
This configuration requires two DB‐9 sync cable.
1. Make sure to stop any recordings in progress.
Note:
You may plug/unplug the sync cable while the analyzer unit is powered on.
2. Connect the female end of the first sync cable to the SYNC OUT port of the first
3. Connect the male end of the first sync cable to the SYNC IN port of the second
4. Connect the female end of the second sync cable to the SYNC OUT port of the
5. Connect the male end of the second sync cable to the SYNC IN port of the third
12
analyzer.
analyzer.
second analyzer.
analyzer.
Host PC Connections Using Various Configurations
CrossSync User Manual