Connecting Two Voyager M3I Usb Analyzers Via The Catc Sync Expansion Card (Acc-Exp-002-X) - LeCroy CrossSync User Manual

Host PC Connections Using Various Configurations
Connecting Two Voyager M3i USB Analyzers via the CATC Sync Expansion Card
(ACC-EXP-002-X)
Two Voyager M3i USB analyzers are connected using their CATC Sync ports which require
an optional expansion board (ACC‐EXP‐002‐X).
Note:
Refer to relevant protocol analyzer user manual for instructions on how to install the expansion
board.
To do so perform the following steps:
1. Make sure to stop any recordings in progress.
Note:
You may plug/unplug the sync cable while the analyzer unit is powered on.
2. Connect the female end of the sync cable to the SYNC OUT port of the first analyzer.
3. Connect the male end of the sync cable to the SYNC IN port of the second analyzer.
Figure 2.2: Two Voyager M3i Analyzers Daisy-chained
CrossSync User Manual
LeCroy Corporation
7