Host PC Connections Using Various Configurations
Connecting Three Analyzers with Built-in Micro-D Sync Ports
The following example shows how to daisy‐chain 3 analyzers with built‐in Micro‐D sync
ports. To do so perform the following steps:
This configuration requires the optional Micro‐D to DB‐9 sync cable (AC030XXA‐X).
1. Make sure to stop any recordings in progress.
Note:
You may plug/unplug the sync cable while the analyzer unit is powered on.
2. Connect the analyzers using the built‐in on‐board Sync/Data ports.
3. Connect the Micro‐D end of the sync cable to the Sync/Data port of the first
4. Connect the male end of the DB‐9 cable to the female end of the second DB‐9 cable.
5. Connect the Micro‐D end of the sync cable to the Sync/Data port of the second
6. Connect the male end of the DB‐9 cable to the female end of the third DB‐9 cable.
7. Connect the Micro‐D end of the sync cable to the Sync/Data port of the third
Figure 2.6: Connecting Three Analyzers
CrossSync User Manual
analyzer.
analyzer.
analyzer.
LeCroy Corporation
11