LeCroy Corporation
Host PC Connections Using Various Configurations
An analyzer connected in a CrossSync configuration may be connected to the Host PC
using any host interface connection supported by the analyzer.
The CrossSync control panel running on the Host PC can then be used to control all
synchronized analyzers for time‐synchronized recording sessions.
CrossSync Cabling for Various Configurations
Connecting a Sierra M6-1 SAS/SATA Analyzer and a Advisor T3 USB Analyzer via the
Micro-D Sync Cable
The devices are connected using their built‐in Sync ports. Perform the following steps:
1. Make sure to stop any recordings in progress.
Note:
You may plug/unplug the sync cable while the analyzer unit is powered on.
2. Connect the Advisor T3 to the Sierra M6‐1 using the built‐in Sync ports via the
Figure 2.1: Daisy-chained Sierra M6-1 and Advisor T3 Analyzers
6
Micro‐D Sync cable.
Host PC Connections Using Various Configurations
CrossSync User Manual