CrossSync Synchronized Time Stamps
LeCroy Corporation
CrossSync Synchronized Time Stamps
Synchronized time stamps make it easy to find the precise point where events from one
bus cross over an adjacent protocol bridge as shown below. Clicking on a packet in one
view will cause the other view to jump to the corresponding time point (taking into
account the Time‐Tune settings).
Figure 3.12: Synchronized Time Stamps
Using the CrossSync Control Panel you can use triggering to find the same packet traveling
across both busses, identifying the point where a specific bus event moves over a bridge.
Either analyzer can be setup as the trigger master. When the trigger event is detected, the
capture stops and the display shows the exact point where the event occurred. Separate
trigger events that operate independently for each side of the bridge can also be defined.
CrossSync User Manual
25