H3C S3100-8C-Sl Quick Start Manual page 50

Quick Start (For Japan)
H3C S3100 Series Ethernet Switches
(1) Outside edge of anchor kit
Figure 3-15 Anchor kit
II. Installation procedure
The wall-mounting procedure is as follows:
1) As shown in Figure 3-16, drill two holes 5 mm across in the
wall on the same horizontal line, with a distance of X mm.
Note:
The distance X between holes varies with devices. For specific
distances, see Table 3-4.
Drill two holes according to the sizes of anchor kits and screws so
that anchor kits could go into the holes, only the edges could
remain outside the wall, and the screws could be fixed on the wall
tightly.
2) Insert anchor kits into the holes and keep only the edges
outside the wall.
(1) (1)
3-18
Chapter 3 Installation