H3C S3100-8C-Sl Quick Start Manual page 64

Quick Start (For Japan)
H3C S3100 Series Ethernet Switches
2) Connect the 12V-RPS DC power supply as follows:
As shown in Figure 3-26, loosen the fastening screws and
remove the air filter from the 12V-RPS DC power socket. (In
the case of no 12V-RPS DC power supply, re-install the air
filter.)
(1) Air filter
Figure 3-26 12V-RPS power socket for an S3100-26TP-EI-W
AC-powered Ethernet switch
Connect one connector (in A direction) of the 12V-RPS DC
power cable (Figure 3-27 shows a recommended 12V-RPS
DC power cable) to the RPS DC power socket of the switch,
and the other connector (in B direction) to the corresponding
12 V power output socket of the RPS power module.
Figure 3-27 12V-RPS DC power cable
(1) (2)
(2) Fastening screw
3-32
Chapter 3 Installation