H3C S3100-8C-Sl Quick Start Manual page 57

Quick Start (For Japan)
H3C S3100 Series Ethernet Switches
II. Connecting AC power cord
1) Connect one end of the chassis grounding cable (coming
with the switch) to the grounding screw on the rear of the
chassis and the other end to the ground nearby.
2) Connect one end of the power cord to the power socket on
the rear panel of the chassis and the other end to an outside
AC power socket.
3) Install the power cord retainer for the AC power cord on
S3100-TP-PWR-EI series Ethernet Switches. Insert the two
ends of the power cord retainer into the slots at both sides of
the AC power input, and then set the power cord into the
notch of the power cord retainer, as shown in Figure 3-20.
(1): Rear panel
(3): Power cord retainer
Figure 3-20 Install the power cord retainer
(2)
(1)
(3)
(2): Power cord retainer holder
(4): Power cord
3-25
Chapter 3 Installation
(4)