H3C S3100-8C-Sl Quick Start Manual page 61

Quick Start (For Japan)
H3C S3100 Series Ethernet Switches
1) Connect one end of the grounding cable (delivered with the
switch) to the grounding screw and the other end to the
ground nearby.
2) Assemble the DC power connector as follows:
Figure 3-23 RPS DC power connector
As shown in Figure 3-23, pass the two power cables through
the air filter, insert them into the corresponding holes, and
tighten them with screw 1 and screw 2. The positive and
negative poles of the power cables must correspond to the
silkscreen above the holes.
Use a flat-blade screwdriver to fix the air filter on the
connector with screw 3 and screw 4, as shown in Figure
3-23.
Use cable ties to bind the two power cables to the protruding
part at the back of the air filter, as shown in Figure 3-23.
3-29
Chapter 3 Installation