Configure Wlan - Gira G1 Assembly And Operating Instructions Manual

Gira G1 (KNX) settings
3.1.2.2

Configure WLAN

The WLAN connection is displayed here if the Gira G1 is already connected to a
WLAN network.
All WLAN networks in the vicinity of the Gira G1 are displayed under "Available
WLAN networks". If you wish to connect the Gira G1 to one of the listed WLAN
networks, proceed as follows:
1 Tap the WLAN network with which you wish to connect the Gira G1.
2 Enter the password for the WLAN network and confirm with [OK].
F The Gira G1 connects to the WLAN network.
WPS (Wi-Fi Protected Setup) is a function that enables you to set up WLAN con-
nections at the push of a button without entering a password.
Note
Router without WPS
If your router does not support WPS (Wi-Fi Protected Setup), you can only set
up your wireless network manually.
Connect the Gira G1 to the WLAN as follows via the WPS function:
1 On the Gira G1, tap [Start WPS configuration].
F This displays a view of all WLAN networks that support WPS.
2 Select the WLAN network to which you want to connect the Gira G1 and con-
firm by tapping [OK].
3 Activate the WPS function on your WLAN router within the next 2 minutes.
F The connection to the WLAN network is established automatically.
Gira G1
Figure 12
Configure WLAN
WLAN connection
Available WLAN net-
works
Options -
Start WPS configura-
tion
22