Setting in the master station
Connect the engineering tool to the CPU module on the master station and set the parameters.
1.
Set the CPU module as follows.
[Project] [New]
2.
Click the [OK] button to add a module label of the CPU module.
3.
Set "Link Direct Device Setting" in "CPU Parameter" to "Extended Mode (iQ-R Series Mode)".
[CPU Parameter] [Memory/Device Setting] [Link Direct Device Setting] [Link Direct Device Setting]
To write module parameters of the RJ71GN11-T2 on a CPU module using an engineering tool, set "Link Direct
Device Setting" to "Extended Mode (iQ-R Series Mode)".
If "Link Direct Device Setting" is "Q Series Compatible Mode", "Write to PLC" cannot be performed.
7 COMMUNICATION EXAMPLES
40
7.1 System Configuration Example