Installing/Removing Fc Network Blades - Fujitsu PRIMERGY BX600 S3 Hardware Manual

Chapter 4 Installing Options

4.3.2 Installing/Removing FC Network Blades

This section explains how to install/remove FC Network Blades.
■ Before installing
●
Notes when installing and removing
Each Network Blade can be installed/removed when the main power of the Chassis is turned on.
• When removing the FC Network Blades or dummy Switch Blade, do not insert your hand into
the Network Blade slot. Doing so may cause electric shock.
• Before setting the handle, make sure that the FC Network Blade is inserted completely to the
slot.
●
FC Network Blade installation location
Network blade
slot 4
●
Available FC Network Blade
The following shows the type of FC Network Blade used for this Chassis.
FC Switch Blade
FC Pass-Thru Blade
Included FC Network Blade options
Before installing the FC Pass-Thru Blade, refer to the following and check the included options.
• FC Switch Blade: FC Switch Blade manual
• FC Pass-Thru Blade:"6.1.2 FC Pass-Thru Blade Specifications" ( p.67)
46
[Rear of the chassis]
Product name
Network blade
slot 3
Model
PG-FCS103
PG-FCB103