Fujitsu PRIMERGY BX600 S3 Hardware Manual page 44

Chapter 4 Installing Options
■ How to remove LAN Network Blade
1
Touch a metal part of the Chassis to discharge static electricity.
2
Remove all LAN cables connected to the LAN Network Blade.
3
Remove the LAN Network Blade.
The figure shows an example for Switch Blade.
1. Grip and pull on the handle.
2. Pull the LAN Network Blade towards
you and remove it.
4
Install the Network Blade/ dummy Switch Blade.
■
" How to install LAN Network Blades" (p.45)
■
" How to install a FC Network Blade" (p.48)
When multiple LAN Network Blades are installed to the Chassis, before removing, use the LAN
Network Blade identification function to check the position of each blade. For details about each
blade identification function, refer to "BX600 Management Blade Hardware Guide".
After removing the LAN Network Blade or dummy Switch Blade, do not operate the Chassis with an
empty slot. Be sure to install a Network Blade or a dummy Switch Blade.
The procedure for removing the dummy Switch Blade is the same as that for removing the LAN
Network Blade. Be sure to keep the removed dummy Switch Blades for later use.
44
(1)
(2)
Handle