Whirlpool WETLV27HW0 Service Manual page 79

WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or
electrical shock.
To Remove the Washer Rear Panel
1. Unplug dryer or disconnect power.
2. Perform the procedures on page 5-14, "Removing the
Dryer Assembly" prior to performing the following steps.
3. Remove Support Brackets. Use a 5/16" driver to remove
the four (4) hex head screws indicated in Figure 1 to dis-
assemble the angle support bracket from the back of the
washer.
IMPORTANT: To prevent damage to frame, do NOT remove
dryer support brackets with the dryer assembly installed.
Figure 1 - Support Bracket Screws
Removing the Washer Rear Panel
Remove the 4
screws indicated.
4. Remove screw holding drain hose to rear panel. Use a flat
bladed screwdriver to unclip the drain hose bracket from
the rear panel. See arrow in Figure 1.
5. Remove Washer Rear Panel. Use a 5/16" driver to remove
the six (6) hex head screws indicated in Figure 2, securing
rear panel to washer cabinet.
6. Remove rear panel and set aside.
27" Stacked Laundry Center
COMPONENT ACCESS
Figure 2
5-19
n