Table of Contents
Advertisement
Fault/Error Codes (Washer) Continued
FAULT/ERROR CODE - DESCRIPTION
Explanation & Recommended Procedure
(Status LED names may vary between makes and models)
F2E3 – SWITCH MISMATCH
The switches do not match the console or are not operating correctly.
• Fault occurs during Diagnostic Test Mode if a switch mismatch is detected.
• See TEST #4: Console and Indicators, page 3-12.
F3E1 – PRESSURE SYSTEM FAULT
Fault is displayed when the Main Control detects an out of range pressure signal.
• Check pressure hose connection from tub to pressure sensor. Is hose pinched, kinked, plugged, or leaking air?
• See TEST #5: Water Level, page 3-13.
F5E1 – LID SWITCH FAULT
Fault is displayed if lid is in locked state, but lid switch is open; control not sensing the strike in the lid lock.
• User presses Start with lid open.
• The main control cannot detect the lid switch opening and closing properly.
• Strike not assembled correctly on the lid.
• Lid lock bezel not installed correctly (must be square to embossing and flush to top).
• See TEST #7: Lid Lock, page 3-15.
F5E2 – LID LOCK FAULT
Fault is displayed if lid lock has not moved into locked position or motor cannot be powered.
• Lid is not closed completely due to interference.
• Check for lock interference with lock striker.
• Wash media buildup (detergent, lint, etc.) is preventing the lock mechanism from sliding.
• Main control detects open lid switch when attempting to lock.
• Main control cannot determine if lid lock is in a locked state.
• See TEST #7: Lid Lock, page 3-15.
F5E3 – LID UNLOCK FAULT
Fault is displayed if lid lock has not moved into unlocked position or motor cannot be powered.
• Check for lock interference with lock striker.
• Main control cannot determine if lid lock is in an unlocked state.
• See TEST #7: Lid Lock, page 3-15.
F5E4 – LID NOT OPENED BETWEEN CYCLES
Fault is displayed if the following conditions occur:
• User presses Start after several consecutive washer cycles without opening lid.
• See TEST #7: Lid Lock, page 3-15.
For Service Technician Use Only
DIAGNOSTICS & TROUBLESHOOTING
FAULT NUMBER
Status LEDs
F
8
4
2
1
F
2
1
F
4
1
F
4
1
F
4
1
F
4
1
27" Stacked Laundry Center
ERROR NUMBER
Status LEDs
E
8
4
2
1
E
1
E
1
E
2
E
2
1
E
4
Continued on next page . . .
2-7
n
Hide quick links:
Advertisement
Table of Contents
