Table of Contents
Advertisement
DIAGNOSTICS & TROUBLESHOOTING
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or
electrical shock.
FAULT/ERROR CODE - DESCRIPTION
Explanation & Recommended Procedure
(Status LED names may vary between makes and models)
F0E0 - NO FAULT
F0E2 - OVERSUDS CONDITION DETECTED
Fault is displayed when suds prevent the basket from spinning up to speed or the pressure sensor detects rising suds level. The
main control will flush water in attempt to clear suds. If the water flush is unable to correct the problem, this may indicate:
• Not using HE detergent.
• Excessive detergent usage.
• Check pressure hose connection from tub to pressure sensor. Is hose pinched, kinked, plugged, or leaking air?
• Mechanical friction on drive mechanism or basket (clothing between basket and tub).
F0E4 – HIGH WATER TEMPERATURE – RINSE CYCLE
Fault is displayed when washer detects water temperature 105°F (40°C) or higher during rinse cycle.
• Hot water getting in. Make sure inlet hoses are connected correctly.
F0E5 – OFF BALANCE LOAD DETECTED
Fault is displayed when an off balance condition is detected.
• Check for weak suspension. Basket should not bounce up and down more than once when pushed.
• Clothing should be distributed evenly when loading.
F1E1 – MAIN CONTROL FAULT
Indicates a main control fault.
• See TEST #1: Main Control, page 3-5.
F1E2 – MOTOR CONTROL FAULT
Indicates a fault of the motor control section of the main control.
• See TEST #3b: Drive System – Motor, page 3-10.
F2E1 – STUCK KEY
One or more keys on the User Interface were actuated for 15 consecutive seconds.
• Fault occurs during Diagnostic Test Mode if a stuck key is detected.
• See TEST #4: Console and Indicators, page 3-12.
2-6
27" Stacked Laundry Center
n
For Service Technician Use Only
Fault/Error Codes (Washer)
See page 2-3 to access Fault Code Display Mode.
* If the Sense/Fill LED is ON, the fault code is represented; if
OFF, the error code is represented.
= ON
FAULT NUMBER
Status LEDs
On
8
4
2
F
F
F
F
F
F
2
ERROR NUMBER
Status LEDs
1
Off
8
4
2
E
2
E
4
E
4
1
E
1
E
2
E
Continued on next page . . .
1
1
1
1
Hide quick links:
Advertisement
Table of Contents
