Troubleshooting - STEINEL IS 140-2 Z-Wave Information

13. Troubleshooting

Malfunction Cause
Without power Fuse faulty,
not switched ON
Short-circuit
Does not switch ON Twilight setting in
night-time mode during
daytime operation
Bulb faulty
Mains switch OFF
Fuse faulty
Detection zone not
correctly adjusted
Does not switch OFF Continued movement
within the detection
zone
Light is in detection
zone and keeps switch-
ing ON as a result of
temperature change
Set to continuous
operation via indoor
two-circuit single
interruption switch
Keeps switching Light being operated is
ON / OFF located in the detection
zone
Animals moving in the
detection zone
Switches ON when it Wind is moving trees and
should not bushes in the detection
zone
Cars in the street are
being detected
Sudden temperature
changes due to weather
(wind, rain, snow) or air
expelled from fans or
open windows
Remedy
New fuse, turn ON
power switch, check
wiring with voltage tester
Check connections
Reset
Replace light bulbs
Switch ON
Replace fuse, check
connection if necessary
Readjust
Check zone and readjust
if necessary or apply
shroud
Check detection zone
Set two-circuit single
interruption switch to
automatic operation
Check detection zone
Check detection zone.
Tilt sensor higher or
fit shrouds to target
sensor; adjust detection
zone or fit shrouds
Check detection zone
Check detection zone
Adjust detection zone or
install in a different place
- 22 -
Malfunction Cause
The device cannot be Z-Wave controller
added (and is not yet too far from the
added) device
The device cannot be
It is already added
added
Status LED flashing
No wireless contact with
for 1 second every
the Smart Friends box or
5 seconds
other Z-Wave controller
Status LED flashing
Critical fault
rapidly all the time
Remedy
Reduce distance from
Z-Wave controller
Install a Z-Wave repeater
Remove device from
existing network
Carry out default reset
Re-start Smart Friends
box or Z-Wave controller
Reduce distance from
Z-Wave controller
Install a Z-Wave repeater
Briefly disconnect device
from the mains power
supply
- 23 -