Technical Specifications; Troubleshooting - STEINEL HF 3360-R AP WS COM1 Information

11� Technical specifications
Dimensions Surface-mounted installation, round Ø
(L × W × H) Surface-mounted installation, square
Concealed installation, round Ø
Concealed installation, square
Output Incandescent / halogen lamp load
Fluorescent lamps, electronic ballast
Fluorescent lamps, uncorrected
Fluorescent lamps, series-corrected
Fluorescent lamps, parallel-corrected
Low-voltage halogen lamps
LED < 2 W
2 W < LED < 8 W
LED > 8 W
Capacitive load
Mains power supply 220-240 V, 50 / 60 Hz max. 2.5 mm
Angle of coverage 360° with 180° angle of aperture
Mounting height 2-2.8 m
Application inside buildings
Sensor system 5.8 GHz high frequency
Transmitter power approx. 1 mW
Time setting 5 s - 15 min + pulse mode (approx. 2 s)
Twilight setting 2 – 1000 lux + teach mode
Manual override
selectable (4 h)
(permanent light)
IP rating Surface-mounted: IP54
Temperature range - 20°C to + 50°C
126 × 52 mm
95 × 95 × 52 mm
124 × 64 mm
94 × 94 × 64 mm
2000 W
1500 W
1000 VA
400 VA
400 VA
2000 VA
100 W
300 W
600 W
176 μF
2
Concealed: IP20
28
12� Troubleshooting
Malfunction Cause
No power at the sensor
n Fuse faulty, not
switched ON
n Short circuit
n Additional two-way
switch OFF
n Fuse faulty
Sensor will not switch ON n Bulb faulty
n Twilight setting set to
night-time mode during
daytime operation
n Additional two-way
switch OFF
n Fuse faulty
Sensor will not switch OFF
n Continuous movement
in the detection zone
n Manual override activat-
ed (red LED lights up)
n Another sensor is par-
allel-connected and still
active
Sensor keeps switching
n Curtains, plants etc.
ON/OFF moving in the sensor's
detection zone causing
the sensor to respond
Sensor responds when it
n Sensor near Wi-Fi or
should not
other wireless commu-
nication sources
LED flashes once every 15 s n Load connected
is too high
Remedy
n Replace fuse, turn ON
power switch, check
lead with voltage tester
n Check connections
n Switch ON
n Fit new fuse, check
connections if neces-
sary
n Change bulb
n Adjust setting
n Switch ON
n Fit new fuse, check
connection if necessary
n Check zone
n Deactivate manual
override
n Wait for time setting
of the other sensor to
elapse
n Check zone
n install at least 2 m away
from the wireless com-
munication source
n Reduce load or use
contactor
29