Cabinet I/O Panel - Silicon Graphics IRIS Series Terminal Manual

IRIS Terminal Specifications
3.5 Cabinet
There are two control panels on the back of the IRIS 1000 and IRIS 1200: an I/O
Panel and a Power Panel. A
system.
Power Switch
The switch is located differently on the IRIS 1000 Terminal and the IRIS
Power
1200 Terminal.
• The
Power
lower-left corner of the Cabinet.
• The
Power
floppy disk drive slot on the front upper-left corner of the Cabinet.

Cabinet I/O Panel

The Cabinet I/O Panel has ports for connecting the Cabinet to the Monitor and
a host computer (see Figures 3-4a and 3-4b) and several control and indicator
features.
•
Port 1
between the Monitor Back Panel and the Cabinet I/O Panel.
•
Port 2
computer.
•
Port 3
• 1 15-pin D socket labeled
Ethernet drop cable.
• 1 flat cable connector labeled
the IRIS 1000.
• 1 BNC socket labeled
from the Cabinet to the Monitor through a coaxial cable.
• 1 BNC socket labeled
signal from the Cabinet to the Monitor through a coaxial cable.
• 1 BNC socket labeled
signal from the Cabinet to the Monitor through a coaxial cable.
• 1 BNC socket labeled
signal from the Cabinet to the Monitor through a coaxial cable.
Version 1.3
Power
switch for the IRIS 1000 Terminal is located on the front
switch for the IRIS 1200 Terminal is located inside the
is the receptacle for the control cable that is connected
is the receptacle for the RS-232 or RS-423 serial line to a host
and are reserved.
Port 4
NOTE: the IRIS 1200 Terminal may have a
boot floppy drive installed inside the Cabinet
near the power switch.
Sync
Red
Green
Blue
IRIS TERMINAL GUIDE
switch controls power for the IRIS Terminal
connects the IRIS Terminal to an
Ethernet
Floppy Drive
is a port for the video sync connection
is a port for transmitting the red video
is a port for transmitting the green video
is a port for transmitting the blue video
connects a floppy disk to
11