Cabinet Power Panel; Power Switch; Software Specification - Silicon Graphics IRIS Series Terminal Manual

IRIS Terminal Specifications
• 1
Reset
button resets the processor and this in turn resets the rest of the
system. After the
must be rebooted. This button and the
Reset
Monitor. Either button may be used to halt the system.
• 1
Halt
• 1 alphanumeric diagnostic LED labeled
Panel indicates system status and displays the results of startup
diagnostics (see Section 6.9 and Appendix A).
• A series of nine DIP switches labeled
Cabinet I/O Panel. These switches control the IRIS Terminal's serial
line baud rate, startup diagnostics and boot environment (see
Appendix A).

Cabinet Power Panel

The Cabinet Power Panel has two power outlets and a power plug (see Figure
3-4a and 3-4b).
• 1 male 3-pin input power plug labeled
the IRIS Terminal system.
• 1 switched 2-amp power outlet labeled
the Monitor.
• 1 unswitched 3-amp convenience outlet labeled
power for peripheral equipment.
• 1 10-amp circuit protector (IRIS 1000).
• 1 15-amp circuit protector (IRIS 1200).

Power Switch

The switch located on the front of the Cabinet controls power for the
Power
Cabinet and the Monitor. It does not control the power for any auxiliary
equipment connected to the Cabinet through the convenience outlet.

3.6 Software Specification

The UNIX distribution tape contains host software that resides on the host
computer and terminal software that is downloaded into the IRIS Terminal
each time it is booted. See Appendix D for a description of the VAX/VMS
software distribution tape.
Version 1.3
button is located on the Cabinet I/O Panel. Pressing this
Reset
button and
Halt
LED indicates that the processor is stopped.
IRIS TERMINAL GUIDE
button has been pressed, the IRIS Terminal
Halt
light on the IRIS Control Panel on the
Configuration
Monitor
light correspond to the
on the Cabinet I/O
Status
is located on the
provides power for
Power
provides power for
3A Max
13
provides