Silicon Graphics IRIS Series Terminal Manual page 64

60 IRIS TERMINAL GUIDE
Serial Line
If the IRIS Terminal is connected to the host computer via a serial line, then a
demonstration program can, be downloaded in the same way as the terminal,
software (see Section D.3).
1. Set the
9) for a normal serial line boot. They should be set to "01100"
where "0" means
2. Login to the host computer.
3. Set the default directory to the directory containing the IRIS Terminal
software.
4. Define the symbol IRIS$INPUT to be the name of the demonstration
program.
5. Download the demonstration programs.
The IRIS Terminal initially displays a series of dots to indicate that downloading
is underway. The introduction to the demonstration program will appear after
a few minutes. To choose a demonstration program, hold down the right mouse
button, move the cursor over a menu entry and release the button.
Floppy Disk
Some demonstration programs can be downloaded into the IRIS Terminal.
These are stored on floppy diskettes.
1. Set the
9) to "01000" where "0" means
Appendix A).
2. Remove the paper insert from the floppy disk drive before inserting
a diskette. Be sure to replace it when the disk drive is not in use.
3. Insert a diskette into the floppy disk drive.
4. (IRIS 1000) toggle the
drive to the
5. Set the
position.
Boot Environment
Closed
USERNAME: IRIS
PASSWORD:
$ SET DEFAULT IRIS$DISK:[IRIS.FORTR1C]
$ DEFINE IRIS$INPUT FLIGHT.
$ RUN DLIRIS
Boot Environment
Power
position.
On
switch on the Monitor Control Panel to the
Power
configuration switches (switches 5 through
and "1" means
Open
configuration switches (switches 5 through
Closed
switch on the back of the floppy disk
Appendix D
(see Appendix A).
and "1" means (see
Open
On
Version 1.3