To Attach A Tip - Keysight Technologies N2750A User Manual

To Remove a Tip
Hold the probe in one hand while holding the body of the tip in the other hand.
Gently pull the probe tip straight off the probe.
Figure 3

To Attach a Tip

1 Orient the new tip as shown in the following figure. For solder-in and socketed
2 Gently press the tip onto the probe. Never apply excessive force when attaching
Figure 4
N2750/1/2A User's Guide
Do not remove the tip by pulling on the tip leads.
CAUTION
Do not pull on the tip leads
tips, you can orient the tip such that the blue lead is labeled lead A or B.
the tip.
Aligning the Tip to the Probe
1
Using the Probes
11