Printing Recorded Files; After Printing; Series P.u. Monitors - Pentair HAFFMANS RPU-352 Instruction Manual

2

21.3 PRINTING RECORDED FILES

ATTENTION
!
When a monitor has been connected the display changes to
serial number and the word
show its function. Press this button. The display changes to
recorded files are printed out. All the pages of the printed graphs, results and listed data for one
recording run are identified by the same unique file number (200 series monitors) or print run
number (100 series monitors).

21.4 AFTER PRINTING

After the printing is finished the print run can be started again.

21.4.1 200 SERIES P.U. MONITORS.

After all the files have been printed the display changes to
erase the files ,the 200 series monitors will only switch off when they have no files stored. Leave
the monitor on charge for at least 15 minutes. During that time the battery charge rate will show
on the display and after about 15 minutes the monitor will switch itself off automatically. When
the idle lamp on the monitor has stopped flashing you can disconnect the monitor and record
more files.
ATTENTION!
21.4.2 100 SERIES P.U. MONITORS.
After all the files have been printed the battery charge rate will be shown on the RPC-80
display. Wait until the trickle charge level before you disconnecting the monitor. Don't
disconnect the monitor while the battery is still fast charging.
Page 62 of 112
Do not switch the P.U. Monitor off until all printing has been completed.
Leave the P.U. monitor connected to the printer charger until the
required charging time is over.
PRINT
appears on the bottom line over the left hand button to
Don't disconnect the monitor while the battery is still fast charging.
HAFFMANS RPU 352, RPU 353, RPC 80 RPC 50
"FOUND...",
"PRINTING..."
"ERASE ALL FILES"
RPU 352, RPU 353, RPC 80, RPC 50
and the monitor
and all the
OK
Press to