Recording; Stopping The Recording; Screen Temperature - Pentair HAFFMANS RPU-352 Instruction Manual

2

6 RECORDING

Only for PRU-353:
The temperature of the probes, the pressure sensor reading and the elapsed
recording time are shown on the display throughout the recording run.

6.1 STOPPING THE RECORDING

When the instrument exits from the pasteuriser you can stop the recording by
activating the top right switch ( ) or by unplugging either probe. Recording will
also stop after the maximum time (4 hours) or if the charge in the battery
becomes too low.
As soon as recording stops the results are displayed.
You can record again without erasing the previous file. Use the top right switch
to access the main menu and then select "Record Again". (See "Results"
section.)

6.2 SCREEN TEMPERATURE

The display screen will switch off if the instrument is too hot (above 70° C). This
avoids damage to the screen. Recording will continue normally under these
conditions and the flashing green indicator lamp shows that the instrument is
operating. Normal display operation will resume as soon as the instrument has
cooled.
Warning
.
*
The illustration shows the English language version in °C and bar. The text changes according to the language and
units selected for the display.
RPU 352, RPU 353, RPC 80, RPC 50
The instrument should never be operated at temperatures above
the maximum ambient temperature shown in the specifications
HAFFMANS RPU 352, RPU 353, RPC 80 RPC 50
Stop
recording
Animated
indicator
Elapsed
recording time
*
.
Page 23 of 112