Kgeneral Maintenance; Daily; Periodically; Lroutine Maintenance - Larius Dragon Liner Operating And Maintenance Instruction Manual

Self-propelled line striper
Table of Contents

Advertisement

DRAGON LINER
Close the re-circulation valve (J3).
Reposition the re-circulation tube within the tank.
Remove the nozzles from the guns and wash them separately.
Turn the pressure adjustment (J6) handle slightly clockwise
to make the machine function at minimum pressure (pump
activated).
Point the manual gun (J7) into a container (J8), drain the
residual paint and wait for the wash fluid to come out clean.
J8
www.larius.eu
18
J3
J7
K
GENERAL MAINTENANCE

DAILY

• Clean the filters;
• Clean the nozzles;
• Clean all the varnish circuit with a specific product;
• Check the fuel motor (see the maintenance table).

PERIODICALLY

• Check the pumping gaskets draft (if the product draws,
replace gaskets);
• Clean the mobile parts from the varnish deposits (clutch
traction, spray guns, etc.);
• Check the gun cables tightening, the wheel block and the
traction;
• Check that the tubes and all the fittings are correctly locked.
ROUTINE MAINTENANCE
L

CHECK ON THE PACKING NUT

The gaskets do not need adjusting. The ring nut is only used
to fit and remove gaskets and for topping up the oil.
Always disconnect the electrical supply and
discharge the pressure in the pump unit (open
the discharge valve) before carrying out any
maintenance.
Wait 30 seconds before proceeding with mainte-
nance operations to allow any residual electricity
to be discharged.
Use the lubricant (L1) provided (ref. 16340) to make it easier
to slide the piston inside the seal pack and to substitute
the air with oil.
L1
Ref. 16340
Oil ring
Ed. 002 - 01/2017

Advertisement

Table of Contents
loading

Table of Contents