Table of Contents
Advertisement
DRAGON LINER
G
WORKING
SETUP PROCEDURE
•
Use the tooling after performing all the SETTING UP ope-
rations above described.
•
Make sure that all the levers are in the "DISENGAGED"
position.
•
Check that there is enough unleaded petrol.
Turn fuel (G1) knob to "ON".
G1
•
Activate the motor start control using the the self-coiling
starter (G2).
G2
•
Open the re-circulation valve (G3).
•
Turn pressure regulating knob (G4) clockwise a little so
that the machine idles.
•
Visually check that the product starts to re-circulate within
the tank.
www.larius.eu
14
•
Close the re-circulation valve (G3).
•
Open the taps (G5) and (G6) of the guns.
•
Turn the pressure adjustment handle (G4) to the necessary
operating value (120 ÷ 190 bar).
G6
G5
G4
-
•
Release the brake on the rear wheel using the lever (G7),
in order to be able to move the machine more easily and
accurately.
G7
A = Disconnected block
B = Connected block
G3
+
A
B
Ed. 002 - 01/2017
Advertisement
Table of Contents
