Table of Contents
Advertisement
ADJUSTING PUMP UNIT SPEED
•
Move the motor acceleration lever (G8) gently to increase
or decrease the speed of the pump.
During the painting operation it is normally recommended
to maintain the position of the accelerator lever (G8) at
about 3/4 of its run.
G8
H
PAINTING OPERATIONS
•
In order to use the spray-guns, open the valve (H1) located
at the intake filter's outlet. In this manner both line-marking
spray-guns will have the possibility of dispensing paint.
•
The machine is outfitted with a manual gun with a 15-meter
tube to perform roadside writings with paint templates.
The gun is positioned on the spraying arm and can be
unhooked.
Ed. 002 - 01/2017
•
Press the advancement lever (H2) and begin to work based
on the set cycle by activating the manual guns control
lever
SPRAY ADJUSTMENT
•
Slowly turn clockwise the pressure control knob to reach
the pressure value in order to ensure a good atomization
of the product.
•
An irregular and marked spray on the sides indicates a
low working pressure. On the contrary, a too high pressure
causes a high fog ("overspray") and waste of product.
•
In order to avoid excess paint pressure, do not spray if
not simultaneously advancing with the machine.
•
Always paint with regular parallel bands coats (manual guns).
•
Keep a safety and constant distance between the gun
and the support to be painted and also keep yourselves
perpendicular to it.
H1
DRAGON LINER
H2
NEVER point the spray gun at yourselves or at
other people. The contact with the casting can
cause serious injuries.
In case of injuries caused by the gun casting, seek
immediate medical advice specifying the type of
the product injected.
Recirculation - safety valve: when working at the
maximum pressure available, releasing the gun
trigger sudden increases of pressure can occur.
In this case, the recirculation - safety valve opens
automatically eliminating part of the product from
the recirculating tube. Then it closes so as to go
back to the first working conditions.
After the unit's use, follow all procedures for de-
compression and cleaning indicated in the attached
maintenance and use manual.
Upon completion of work, switch the lever into the
resting position.
www.larius.eu
15
Advertisement
Table of Contents
