Troubleshooting; Initializing; Initializing An Sd Memory Card - Oki Pro8432WT User Manual

6. Troubleshooting

This chapter explains initializing, deleting and updating drivers.

Initializing

„ „
This section explains how to initialize an SD memory card and flash memory and how to reset the
equipment settings to their defaults.
You can delete data or settings stored on the printer to restore the settings to how they were at the
time of purchase.
Note
● To enable/disable SD card initialization, in the [Admin Setup] menu go to [Others Setup] > [Storage Common Setup] >
[Enable Initialization] and select [Yes]/[No].
Memo
● In order to access the [Admin Setup] menu, an administrator password is required. The default password is "999999".
Initializing an SD memory
card
Carry out initialization of an SD card when
inserting a card that has been used in other
equipment or when the SD Card is not properly
recognized.
An SD memory card is used as storage for
spooling when making multiple copies, for saving
secure print/ encrypted print data, and for form
data and macros. Initialization deletes stored
data.
An SD memory card has three partitions. They
are PS, Common, and PCL. When an SD memory
card is initialized, each partition is respectively
divided into the percentage specified (in the
factory default setting, PS: 30%, Common:
50%, PCL: 20%). You can also format particular
partitions individually.
If an SD memory card that has been installed to
another device is installed to the printer, or if the
SD memory card installed to the printer cannot
be detected anymore, [To SD format, press
[Enter] To shut down, press [Cancel]] may
appear on the display when the printer is turned
on. In such a case, press the <ENTER>. (Data
stored in the SD memory card is deleted.)
If you select <CANCEL>, the device shuts down.
Formatting the Entire Area
You can format the entire area of the SD
memory card installed in the printer.
Note
● When you initialize the entire area of an SD memory card,
the following data is deleted.
- Stored job data subject for [Shared Print], [Private
Print].
- Custom demo data
- Form data
1 to select [Admin Setup] and
Press
then press the <ENTER> button.
2
Enter the administrator password using
the numeric keypad.
The default password is "999999".
3 Press the <ENTER> button.
4
Select [Others Setup], press
<ENTER>, and press
Card Setup].
5 to select [SD Card Setup] and
Press
then press the <ENTER> button.
6
Make sure that [Initialize] is selected
and then press the <ENTER> button.
7 Make sure that [Execute] is selected
and then press the <ENTER> button.
A message appears notifying you that continuing
will automatically restart the system. Select
[Yes] to continue.
- 73 -
6
to select [SD