Oki Pro8432WT User Manual page 47

Calibration
Item
Auto Density
Mode
Adjust Density
Adjust
Registration
Color Density Cyan/Magenta/
Yellow/White
Density
Print Tuning
Pattern
Cyan/Magenta/ Highlight
Yellow Tuning
Mid-Tone
Dark
Settings
On/Off
Execute
Execute
-3,-2,-1,
0,+1,+2,+3
Execute
-3,-2,-1,
0,+1,+2,+3
-3,-2,-1,
0,+1,+2,+3
-3,-2,-1,
0,+1,+2,+3
- 47 -
Changing the Equipment Settings
Explanation
Selects whether density adjustment and TRC
compensation is automatically performed.
[On]: Density adjustment is automatically run
under the engine-specified conditions, and
reflected in TRC compensation.
[Off]: The printer does not voluntarily run
density adjustment.
If Execute is selected, the printer will immediately
adjust density and reflect it in TRC compensation.
This adjustment must be executed when
the printer is idling. It can become invalid if
executed in any other state.
When this menu is selected, the printer performs
AutoAdjust Registration.
This adjustment must be executed when the
printer is idling.
Adjusts the engine density.
Prints the pattern for the user to adjust TRC.
Ordinarily, this function is not needed
because TRC is automatically adjusted to the
recommended levels through density adjustment
and TRC compensation.
Adjustment results will be reflected as offset
values (addition) to the corrections through the
Adjust Density/TRC Compensation function.
Adjusts highlight (light area) of the TRC.
+ = Darker
- = Lighter
Adjusts mid-tone area of the TRC.
+ = Darker
- = Lighter
Adjusts dark area of the TRC.
+ = Darker
- = Lighter
3