Optional: Install The Traditional Up Racks - M86 Security MSA Installation Manual

Optional: Install the Traditional UP Racks

After you have installed the inner rails on the chassis, you are ready to install the
outer rails of rail assemblies to the rack.
NOTE: The rails are designed to fit in the racks with the depth of 28" to 33".
• Determine the placement of each component in the rack before you install the rails.
• Install the heaviest server components on the bottom of the rack first, and then work up.
1. In the package, locate a pair of front (short) and rear (long) brackets. Please
note that the brackets are marked with Up/Front Arrows (front) and Up/Rear
arrows (rear).
2. Secure the front (short) bracket (marked with the Up/Front arrows) to the outer
rail with two Type G screws. (See the previous page for a description of the
Type G screw.)
3. Attach the rear (long) bracket to the other end of the outer rail and secure the
rear (long) bracket to the outer rail with a Type G screw as shown below.
4. Measure the depth of your rack and adjust the length of the rails accordingly.
5. Repeat the same steps to install the other outer rail on the chassis.
6. Secure both outer rail assemblies to the rack with Type H screws and Type I
washers. (See the previous page for descriptions of Type H and Type I hard-
ware components.)
7. Slide the chassis into the rack as shown below.
NOTE: The chassis may not slide into the rack smoothly or easily when installed the first
time. Some adjustment to the slide assemblies might be needed for easy installation.
M86 S I G
ECURITY NSTALLATION UIDE
P S P
RELIMINARY ETUP ROCEDURES
R M S
ACK OUNT THE ERVER
9