Rack Mount Instructions For 500 Series Servers; Rack Setup Suggestions; Install The Inner Slides; Install The Outer Slides - M86 Security 350 Installation Manual

Rack Mount Instructions for 500 Series Servers

Rack Setup Suggestions

• Determine the placement of each component in the rack before you install the
rails.
• Install the heaviest server components on the bottom of the rack first, and then
work up.

Install the Inner Slides

1. Locate the right inner slide, (the slide that will be used on the right side of
chassis when facing the front panel of the chassis).
2. Align the four (4) square holes on the right inner slide against the hooks on the
right side of the chassis as show below on the left.
3. Securely attach the slide to the chassis with two M4 flat head screws and repeat
the steps 1-3 to install the left inner slide to the left side of the chassis.

Install the Outer Slides

1. Measure the distance from the front rail of the rack to the rear rail of the rack.
2. Attach a short bracket to the rear side of the right outer slide, and a long bracket
to the front side of the right outer slide as shown above on the right.
3. Adjust the short and long brackets to the proper distance so that the chassis
can snugly fit into the rack.
4. Secure the slides to the cabinet with screws.
5. Repeat steps 1-4 for the left outer slide.
M86 S I G
ECURITY NSTALLATION UIDE
P S P
RELIMINARY ETUP ROCEDURES
R M S
ACK OUNT THE ERVER
7