Table of Contents
Advertisement
P
S
P
RELIMINARY
ETUP
ROCEDURES
12
R
M
S
ACK
OUNT THE
3. Attach the front (short) bracket to the front end of the rack, and secure it to the
rack with two Type H screws and Type I washers as shown below. (See the
previous page for descriptions of Type H and Type I hardware components.)
4. Attach the rear (long) bracket to the rear end of the rack, and secure it to the
rack with two Type H screws and Type I washers as shown below. Repeat the
same steps to install the other outer rail to the other side of rack.
5. Measure the depth of your rack and adjust the length of the rails accordingly.
Then, secure the rails to the chassis with Type G screws.
ERVER
M86 S
I
G
ECURITY
NSTALLATION
UIDE
Advertisement
Table of Contents
