Table of Contents
Advertisement
P
S
P
RELIMINARY
ETUP
ROCEDURES
General Safety Information
Server Operation and Maintenance Precautions
16
G
S
I
ENERAL
AFETY
NFORMATION
WARNING:
Observe the following safety precautions during server operation and mainte-
nance:
WARNING: If the server is used in a manner not specified by the manufacturer, the
protection provided by the server may be impaired.
WARNING: M86 Security is not responsible for regulatory compliance of any server that
has been modified. Altering the server's enclosure in any way other than the installation
operations specified in this document may invalidate the server's safety certifications.
CAUTION: Never pile books, papers, or other objects on the chassis, drop it, or subject it
to pressure in any other way. The internal circuits can be damaged, and the battery may
be crushed or punctured. Besides irreparable damage to the unit, the result could be
dangerous heat and even fire.
CAUTION: There are no user-serviceable components inside the chassis. The chassis
should only be opened by qualified service personnel. Never disassemble, tamper with, or
attempt to repair the server. Doing so may cause smoke, fire, electrical shock, serious
physical injury, or death.
WARNING: In HL servers, multiple sources of supply exist. Be sure to disconnect all
sources before servicing.
• Do not insert objects through openings in the chassis. Doing so could result in
a short circuit that might cause a fire or an electrical shock.
• Do not operate the server in an explosive atmosphere, in the presence of flam-
mable gases.
• To ensure proper cooling, always operate the server with its covers in place. Do
not block any openings on the chassis. Do not place the server near a heater.
• Always exit the software application properly before turning off the server to
ensure data integrity.
• Do not expose the server to rain or use near water. If liquids of any kind should
leak into the chassis, power down the server, unplug it, and contact M86 Secu-
rity technical support.
• Disconnect power from the server before cleaning the unit. Do not use liquid or
aerosol cleaners.
M86 S
I
G
ECURITY
NSTALLATION
UIDE
Advertisement
Table of Contents
