Table of Contents
Advertisement
Chapter 6: Cabling the Networking Ports and Powering On the Switch
Powering On the Switch
76
Before powering on the switch, review the information in "Power
Specifications" on page 90 for the power specifications.
Warning
Power cord is used as a disconnection device. To de-energize
equipment, disconnect the power cord. E3
Note
Pluggable Equipment. The socket outlet shall be installed near the
equipment and shall be easily accessible. E5
To power on the switch, perform the following procedure:
1. Install the power cord retaining clip on the AC power connector on the
rear panel of the switch, as shown in Figure 35.
Figure 35. Installing the Power Cord Retaining Clip
Advertisement
Table of Contents
